0 0

Fixation bracket assembled L/N

The Fixation bracket assembled L/N is an accessory for NeoR lightweight formwork and LOGO wall formwork and is used to secure the position and uplift protection of the formwork panels. Furthermore, upright/lying LOGO or lying NeoR panels can be held in place at low formwork heights without bracing if it is not possible to use the tensioning set, Modular foundation tie clamp or foundation clamp.

  • Uplift protection
  • Single-sided forming is also possible
  • Quick and easy installation
  • Integrated hook head bolt
  • Easy and secure anchoring with the Concrete screw 16x130

Application information

The Fixation bracket assembled L/N is used wherever NeoR lightweight formwork is used horizontally with low formwork heights and the lower tensioning of the panels cannot be achieved using perforated tape or foundation clamps. With LOGO formwork, the Fixation bracket can be used with both vertical and horizontal panels. The integrated Hook-headed bolt allows the Fixation bracket to be fitted to the respective formwork panel in a flash. To do this, the Hook-headed bolt only needs to be fitted to the slotted hole in the cross profile and anchored back into the installation surface using the Concrete screw.

Single-sided forming

The Fixation bracket also enables single-sided forming in conjunction with the Suspending piece for props L/N/A cpl., the Suspending piece and the Foot plate 3 holes as well as the Concrete screw 16x130. The concrete pressure must be taken into account.

Further information on applications, quantities and influence widths for inclined supports can be found in the technical product information.





Write Product Review
No review available for this item.