LOGO.3 panel 30 x 340 cm

The LOGO. 3 panel 30 x 340 cm is a formwork panel in the PASCHAL LOGO.3 formwork range.

With dimensions of 30 x 340 cm, together with the other dimensions 45/40/25/20 x 340 cm, it forms the smaller compensation panels of the 3.40 m formwork height. In addition to the extremely strong, profiled flat steel frame, the panel comprises a birch plywood sheet which is supported by nine multifunctional cross hat profiles.

• Made of profiled, very strong flat steel
• 16 mm Finnish birch plywood, 12 ply
• Fresh concrete pressure absorption of 70 kN/m² compliant with DIN 18218
• Ideal for exposed concrete due to the narrow frame imprint in the concrete
• Ideal panel for the outside corner
• Safe and rapid connection with the wedge clamp
• Compliance with maximum safety standards thanks to the lateral protection system Secuset
• Can be used horizontally for base plate and slab edge formwork
• LOGO.3 is also available in your corporate colours
• Transponders for clear identification

Application information

The PASCHAL LOGO.3 panel 30 x 340 cm can be used anywhere, whether for large-scale forming or for concreting a small but complicated ground plan. Only very few connecting pieces are required for large wall areas, resulting in outstanding forming times.

The LOGO.3 element 30 x 340 cm can also be used horizontally as foundation formwork. Parapets and kickers can be created without additional ties thanks to the LOGO foundation strap. When combined with the slab edge bracket, the panel 30 x 340 cm can be used as slab edge formwork.

Formwork suitable for exposed concrete

The LOGO.3 panel 30 x 340 cm satisfies the stringent requirements for concrete surfaces as only an extremely narrow frame imprint is left in the concrete.

Comprehensive occupational safety

Thanks to its ease of use, the lateral protection system Secuset can be installed safely and efficiently on formwork. The LOGO concreting platform can also be secured to the panels as a working platform.

Special features of the 340 cm-high panel

The 340 cm-high LOGO panel has holes for ties at the same height as the 270 cm LOGO panel. The 270 cm-high panel can therefore be located opposite the 340 cm-high panel and braced using tie rods. This formwork that is higher on one side can then be used as slab edge formwork. This option is used particularly often for lift cores. Outer formwork of 270 cm, inner core formwork of 340 cm, this then remains in the lift core as slab edge formwork up until the slab formwork is concreted.

Two tie points are sufficient for the panel height for concreting heights up to 340 cm. If the 340 cm-high LOGO panel is extended in height, the number of tie points is increased to just three for the panel height.

LOGO.3 satisfies customer requirements

To increase your recognition value, the PASCHAL LOGO.3 formwork can be produced in your corporate colours on request.
In addition, thanks to the PASCHAL ident technology, our transponders uniquely identify each LOGO.3 panel.

Please refer to the technical information for further system benefits.

 Discover now virtually

 Watch our product video